Post by Skaggs on Sept 15, 2004 16:07:45 GMT -5
There are two ways to enter the diagnostic mode:
1. ON THE BOX, hold the "+" button in for a few seconds until the mail light begins flashing. (This is the button in the center of the up, down, left, right arrow buttons.) Press the INFO button.
You can page through the informational screens by using the left & right arrow buttons. You can see the TV picture by pressing the "+" button...once will make the diagnostic info about 50% opaque and twice will make it about 20%. A third time will bring you back to 100%.
2. WITH THE REMOTE - You can enter the diagnostic mode with the remote by pressing and holding the pause button for about 10 seconds until the Mail light starts to flash. Press PAGE up and you will enter the diagnostic menu.
1. ON THE BOX, hold the "+" button in for a few seconds until the mail light begins flashing. (This is the button in the center of the up, down, left, right arrow buttons.) Press the INFO button.
You can page through the informational screens by using the left & right arrow buttons. You can see the TV picture by pressing the "+" button...once will make the diagnostic info about 50% opaque and twice will make it about 20%. A third time will bring you back to 100%.
2. WITH THE REMOTE - You can enter the diagnostic mode with the remote by pressing and holding the pause button for about 10 seconds until the Mail light starts to flash. Press PAGE up and you will enter the diagnostic menu.